Kubla Central
DXF drawing - Printable Version

+- Kubla Central (https://www.forums.kublasoftware.com)
+-- Forum: Kubla Cubed (https://www.forums.kublasoftware.com/forumdisplay.php?fid=4)
+--- Forum: General Discussion (https://www.forums.kublasoftware.com/forumdisplay.php?fid=19)
+--- Thread: DXF drawing (/showthread.php?tid=5)



DXF drawing - Bernard - 05-31-2018

Hi Ted,

I try to import a designed finished surface in dxf file format (which was produced by Microstation software by our client) into Kubla Cubed, but not successful. The Kubla prompt that the dxf is not a valid file. Could you please help to resolve this problem. (This is the 1st time I encountered this type of problem) Your early respond will be appreciated. FYI, the dxf file can be opened by Autocad program.

The screen shot is attached herein for your reference.


Thanks and regards,
Bernard


RE: DXF drawing - Ted Woods - 06-01-2018

(05-31-2018, 12:05 PM)Bernard Wrote: Hi Ted,

I try to import a designed finished surface in dxf file format (which was produced by Microstation software by our client) into Kubla Cubed, but not successful. The Kubla prompt that the dxf is not a valid file. Could you please help to resolve this problem. (This is the 1st time I encountered this type of problem) Your early respond will be appreciated. FYI, the dxf file can be opened by Autocad program.

The screen shot is attached herein for your reference.


Thanks and regards,
Bernard

Hi Bernard

No problem can you send the file to us.  Out of interest is the finished surface a TIN and if so can it be exported as LandXML.  

It might be easier to try the LandXML export, import.

-Ted


RE: DXF drawing - Ted Woods - 06-04-2018

Hi Bernard

 
Thanks for sending us the DXF file to look at.  

The first thing I try in situations like this is to delete all the unrequired entities in a CAD program.  For this I used the free edition of Draftsight.  Then save out this other copy with only the details needed.
 
I tried creating a Kubla Cubed project and the results look OK although I would say they could benefit from some tidying up by adding additional break lines and contours in Kubla Cubed.  The existing has gaps in elevation data especially around the demolition areas (not sure what they are but the recessed pads) that cause nasty triangulation artifacts.  If you were to trace a break line or contour around the base of the demo areas it would look nicer.
 
Also the proposed seems to sometimes have better detail in some areas than others.
 
Did you know that Kubla Cubed now supports importing triangulations.  Do you use Bentley ? You might find instead of exporting these breaklines you can export a LandXML surface and then import into Kubla Cubed as a Triangle Surface.  The only downside in this method is you cannot edit it further in Kubla Cubed.

In regard to the overall issue we are going to be investing in superior CAD import technology soon.  Expect .DWG and .DGN support soon.