+- Kubla Central (https://www.forums.kublasoftware.com)
+-- Forum: Kubla Cubed (https://www.forums.kublasoftware.com/forumdisplay.php?fid=4)
+--- Forum: General Discussion (https://www.forums.kublasoftware.com/forumdisplay.php?fid=19)
+--- Thread: Different Slope Angles to Bund (/showthread.php?tid=625)
Different Slope Angles to Bund - timetomaketracks - 04-18-2024
Hi all,
I'm sure that there is a simple answer to this one - just can't find it! I need to design an 'L' shaped bund 5m high with 1:1 outer flank and 1:3 inner flank. The berm tool only allows 1:1 or 1:3, not both. Creating a bund with 1:1 flanks and then trying to use the Slope tool doesn't work - any ideas?
Thanks in advance.
RE: Different Slope Angles to Bund - Brandon - 10-16-2025
Interesting challenge! It’s funny how software tools always seem to prefer “either-or” when we need a bit of both. You might try modeling the 1:1 and 1:3 flanks separately and then merging the surfaces — sort of a “DIY L-shaped bund.” Curious to see if anyone’s found a cleaner way around the berm tool’s limitations!