Break Lines

Hi Kevin,

I think the option you need is definitely the 'define point levels' break line.

If you choose this option you can type the level at each point that you have levels on the drawing. However, if you have points where you don't have the level then you can just skip typing the point level by pressing enter or clicking on the 'next' button on the prompt. Entering the levels is not mandatory for every point. The software will interpolate between the levels you give it to get the levels for the points where you haven't typed one.

This feature is often used for things like kerbs which are going around a curve. As you say, in this scenario the levels are typically only specified at the start and the end of the curve, so this option is very useful.

Leo