Swales

I have to assess the quantities of a long swale around a property. As typical the swale is wider at the top than it is at the bottom, meaning that the batters are in effect negative. However, by design the batter is steeper on one side than it is on the other (see attached profile)

How do I do this inside of Kubla?

Thanks

Kevin

Hi Kevin,

I find the easiest and quickest way is as follows:
Use Feature Surface,
For the top of the swale levels, use Outline, Draw, Use ground levels and mark out the perimeter.
For the swale base, use Breaks, Draw, Define Levels and enter levels as you mark out the base perimeter.
Click ok and job done.

Cheers

Tim