Welcome Guest, Not a member yet? Create Account  


Copy & Paste Outlines

#1

I have created an outline for topsoil strip.  On another TAB (phase), I want to use that same outline to setup a platform so that I can determine the site balance elevation.  I am pretty sure that I am getting the copy part right on the topsoil strip phase, select all points using the arrow feature in the upper left hand corner of the outline coordinates list and then doing a control-C, but I cannot get these coordinates pasted on the next phase.  What is the sequence of operations I must do on the new phase to paste the coordinates?
Reply


Messages In This Thread
Copy & Paste Outlines - by djungst - 01-25-2022, 01:52 PM
RE: Copy & Paste Outlines - by Ted Woods - 01-27-2022, 12:01 PM



Users browsing this thread:
1 Guest(s)