Welcome Guest, Not a member yet? Create Account  


[HELP] 2019 Crashing at outline creation

#1
(This post was last modified: 04-30-2019, 12:59 AM by conradccb.)

Hi all,
My Kubla 2019 keeps crashing when trying to apply creation of a Manual (but auto calculated) outline of Design Contours.
The design contour has ~4000
It has an Existing surface uploaded via DXF. 
This is the point before it closes. Once I click OK, the program just disappears.
Note it also crashes if I manually draw a smaller area (jsut around the lower basin).
Any ideas?
[Image: s0gg0BQ.png]
Reply


Messages In This Thread
[HELP] 2019 Crashing at outline creation - by conradccb - 04-30-2019, 12:42 AM



Users browsing this thread:
2 Guest(s)