Wrong Scale set up

When I set up the drawings I accidently set up the wrong scale. 
because of the wrong scale all my contours are wrong as well, and I had to draw them by hand. 
Is there a way to scale the contours to your drawing?

When I set up the drawings I accidently set up the wrong scale. 
because of the wrong scale all my contours are wrong as well, and I had to draw them by hand. 
Is there a way to scale the contours to your drawing?

Hi Martinvb,

Welcome to our forum.

When starting a new project, the first thing to do is add a Site Plan and set the scaling as required. Scaling cannot be applied after data has been added. Currently there isn't a tool for scaling contours to drawings, however we do have an in-house tool that can do this. If you email your project to us at support@kublasoftware.com we should be able to fix the problem.

The Quick Measure Tool can be used to check any known length against your drawings, as demonstrated in this video and documented in our online manual: https://www.kublasoftware.com/support/do...-tool.html

Hope this helps!

Dave.

<p><br></p>

Thank you for your offer, I restarted the project with the right scaling this time.